SPECIFICATIONS

DIMENSIONS (HWD)
2 1/2" x 4 1/4" x 1" (63.5 mm x 108.5 mm x 25.0 mm)
Note: depth does not include antenna

WEIGHT
5.6 oz (158.75 g)

POWER

• 10.5 - 18 VDC; (13.5 VDC nominal operation voltage)
• Power over Ethernet (PoE) Class 2

MEMORY

• 16 MB of FLASH
• 16 MB of SDRAM

RADIO SPECIFICATIONS

• Frequency: 2.4GHz
• Operating Channels: 11 – 26
• Modulation Technique: DSS
• Output Power: Region/country specific
• Coverage Area: 165 feet (50.2m)

FIRMWARE/SOFTWARE SPECIFICATIONS MANAGEMENT

• Built-in browser-based management with User Name/Password authentication
• IP Configuration: Static IP or DHCP client (default is static, 192.168.1.140)
• Communications: ZigBee, TCP/IP

FRONT COMPONENTS

• LEDs
• PWR/STATUS - A green LED that blinks to indicate the device is installed and communicating properly. Power ON, but no master connection, is indicated with a solid light, Power OFF is indicated with no light
• LAN - A green LED indicates an Ethernet connection is established. The LED blinks to indicate both sending and receiving information via Ethernet
• RF - The LED is solid when end devices are connected; end devices not connected is indicated with no LED light; the LED blinks to indicate activity
• Antenna Mount: A reverse SMA connection that supports a 2.4GHz antenna.
• ID Button: When used in conjunction with NetLinx Studio, sets the device and system numbers for the NXR-ZGW. Press and hold for approximately 30 seconds to return the NXR-ZGW to factory default settings.

REAR COMPONENTS

• Power connector : 2-pin 3.5mm captive-wire connector
• Power Over Ethernet (PoE) - Powers the device through the CAT5 cable. Both Power and Data can be transmitted simultaneous through the CAT5 cable when using the appropriate equipment.
• Ethernet Port: 10BaseT Modular (RJ-45) connector - connects the NXR-ZGW to your LAN and/or to connect your third party device to the LAN when the NXR-ZGW is used as a gateway.

ENVIRONMENTAL

• Operating Temperature: -30ºC (-22ºF) to 70ºC (158ºF)
• Relative Humidity: 5% to 85% non-condensing; intended for indoor use only

CERTIFICATIONS
FCC ID: CWU-ZGW, IC ID: 5078A-ZGW, CE, IEC-60950, TELEC

INCLUDED ACCESSORIES

• Rubber feet
• Velcro mounting strip
• 2.4GHZ, MONO, RSMA, 3.5IN, 2.0DBI Antenna (70-0012-SA)
• Power Supply (24-5791-SA)

Learn important installation, configuration and programming techniques in the following course(s) from AMX University:

• Getting Started with Wireless Technology (Online)

For schedules and registration for this and any AMX University course, visit www.amx.com/training.