
Quick Start Guide - UDM-RX01 Endeleo Multi-Format Receiver
PDF | 188 KB
| Rev. A
Endeleo UDM Series Distributed Media
PDF | 2.65 MB
UDM-RX01 Firmware
001 | 32 KB
| v 1.18
Installed at the display device, the UDM-RX01 converts the signal received from the UDM-1604 or UDM-0102 Multi-Format Distribution Hub to standard audio/video signals.
With intelligent receiver technology, each UDM-RX01 is powered remotely from the Multi-Format Distribution Hub via the Cat 5, 5e or 6 cable. As the hub is switched from one video/audio source to another, the receiver detects a change in signal and automatically switches the Plasma or LCD screen to its new video format. Distances of 1,000 feet/300 meters are supported at 1280x1024; higher resolutions are supported at shorter distances.
The UDM-RX01 incorporates the latest chip technology for advanced skew compensation. Integrated Device Management (IDM) enables the receiver to provide full control sequences for both IR and Serial control. These control sequences are stored in the receiver, providing the ability to switch on/off display devices on an ad-hoc or scheduled basis. Multiple commands can be processed by the receiver and closed loop feedback is possible for use with the AMX NetLinx Control System.
NETWORK INTERFACE: 10baseT SERIAL INTERFACE: 9600, 8 bit, No Parity, 1 Stop Bit INFRARED CONTROL
VIDEO SUPPORT
AUDIO SUPPORT
POWER: Remotely powered by the UDM Multi-Format Distribution Hub
DIMENSIONS (HWD): 1" x 6 11/16" x 4 11/16" (25 mm x 170 mm x 120 mm)
WEIGHT: .66 lb (300 g)
NOTE: No A/V display interface cables supplied.