最后更新： 06月08日
Release Notes
Products: JPK-1300-UA, JPK-1300-EK
Description: AMX Jetpack Kit includes Receiver, Wallplate Transmitter, and Keypad
FG#: AMX-VTK0001 (US and Asia)
AMX-VTK0001EK (Europe and UK)
File Name: SW_AMX-JPK-1300_v1.04.03.bin
Release Date: 3/23/2023
Firmware Version: V1.04.03
- Receiver： V1.04.03
- Wallplate TX: V1.01.11
- Keypad： V1.01.08
- Web： V1.00.25
1. Prerequisites
2. Features added in this release
3. Fixes in this release:
4. Known Issues
5. Programming Information
6. Notable Points
----------------------------------------------------------
1. Prerequisites
----------------------------------------------------------
- Requires v1.03.10 or later to update
----------------------------------------------------------
2. Features added in this release:
----------------------------------------------------------
- None
----------------------------------------------------------
3. Fixes in this release:
----------------------------------------------------------
- Optimized Web Reboot feature so it will restart in the login interface automatically
- Resolved Save/Load config problem causing serial port commands to not be exported/imported properly in ASCII
Fixes in previous v1.04.02
Webgui
- Clarify the private key supported format (both .key and .pem) for HTTPS certificate on the Webgui
FW
- Fix feedback issue on Telnet/SSH when pressing either the “SOURCE” button on the Wall-plate TX
or pressing “HDMI 1”, “HDMI 2” and “USB-C” button on the keypad
Fixes in previous V1.04.01
MCU
- Optimize time zone setting related operations
Webgui
- Fixed the time format
- Disable Time Zone function and optimize logic when Set Time
Automatically is set to OFF
- Corrected an issue where saving the Schedule did not notify
user if the save was successful
FW
- Fixed issue where the product would not get the IPv6 address
assigned by IPv6 server
- Fixed audio/video issue when switching output mode between
"sharing the screen" and "Samsung DEX" using Type-C channel
API
- Fixed "set dns" command
- Corrected the IPV6 Mask Prefix (aka. Subnet Prefix Length) received
from the API command "get ipv6" to properly match the Webgui value
----------------------------------------------------------
4. Known Issues
----------------------------------------------------------
----------------------------------------------------------
5. Programming Information
----------------------------------------------------------
- IMPORTANTE: After upgrading the firmware, it is best to perform a factory reset, to make sure any new or updated
parameters will get properly initialized
----------------------------------------------------------
6. Notable Points
----------------------------------------------------------
- USB2.0 SPDIF Audio requires 8 sec to be detected by USB-C Source when using USB2.0 Type-C to Type-C cable
- Below is a summary to get Video and full functionality of Jetpack USB-C (DisplayPort, KVM and SPDIF Audio over USB2.0)
-- For USB Type-C Video: The cable and source must support "DP Alt Mode"
-- For USB-C Cable: Jetpack supports a maximum AV date rate up to 10Gbps (4K60:420 or 4K30/444), so the data transport
rate of the cable needs to support up to 10Gbps.
--- Based on DP Alt Mode for USB-C standard, USB-C Cable need compliant to:
--- USB3.1 Gen1 (Equal to USB3.0) – 5Gbps (Lowest requirement to get full-feature of Jetpack USB-C connection)
--- USB3.1 Gen2 – 10Gbps (Recommend requirement to get full-feature of Jetpack USB-C connection)
--- Or higher version
下载
