DXLink Fiber Receiver Firmware v1.0.1

Note: this is an old version. The current version is: DXLink Fiber Receiver Firmware v1.2.1. ×

Last Updated: 3月15日

Prerequisites:

  • Enova DGX enclosures will need Enova DGX 8/16/32 Master FW v4.2.379 and Enova DGX 8/16/32 FW V1.6.1.1 (or later)
  • NetLinx Studio V3.3 - Build 525 or later

Notable Points:

  • Please read the documentation in regard to the DIP switches located on the bottom of the Tx/Rx modules before attempting to connect to the network.
  • After a FACTORYAV (ICSP) or RESET FACTORY (telnet) command, a reboot of the RX is required.
  • The RX module uses these solid color screen indications:
    • ORANGE Indicates an HDCP authentication failure with the connected HDMI sink (monitor or other device).
  • If using a hostname in the USB_HID_ROUTE command, the hostname length is limited to 50 characters.

Programming Information

  • No special notes for programming the firmware.

相关产品

  • DXF-RX-MMD

    DXLink™ HDMI 多模光纤接收器,双工

  • DXF-RX-SMD

     DXLink™ HDMI 单模光纤接收器,双工