CTP-1301 Firmware v5.9

Last Updated: Jun 14, 2021

Release Notes

Product: CTP-1301
Description: CT-Series Presentation Connectivity and Transport Kit
FG#: FG1010-710

File Name: SW1010-710_CTP-1301_v5_9
Firmware Version: 5.9
Release Date: 2021-5-27

!! Please read Programming Information for successful upgrade steps!!

1. Prerequisites
2. Features added in this release
3. Fixes in this release:
4. Known Issues
5. Programming Information
6. Notable Points


----------------------------------------------------------
1. Prerequisites
----------------------------------------------------------
- NetLinx Studio v4.3.1519 (or later)

----------------------------------------------------------
2. Features added in this release:
----------------------------------------------------------
- Added new API commands for control via Telnet (see manual for API list)
- Added ability to load and display a logo when no signal is present on a routed input
-- Upload a single png logo file via WebUI
-- Max image size 1280x720 & 60kB
-- Control by WebUI or by NetLinx code
-- VIDOUT_BLANK-<BLACK/LOGO>
-- Choose fixed or moving logo option
-- VIDOUT_LOGO-<FIX IN CENTER, DRAG TOP LEFT, etc>
- Added WebUI and NetLinx support for HDCP OUT setting
-- VIDOUT_HDMI_HDCP-<HDCP_FOLLOW, HDCP_2_2, HDCP_1_4, HDCP_OFF>
- Added WebUI volume control for HDMI output

----------------------------------------------------------
3. Fixes in this release:
----------------------------------------------------------
- Modified serial port pass through info to be string type
- Fixed HDMI OUT HDCP mode persistence over power cycle
- Also made factory default revert to FOLLOW
- Fixed SSL certificate errors
- Fixed USB audio distortion over HDBT link
- Corrected issue where WebUI volume changes would cancel Mute
- Fixed issue causing continual "Custom Event Type 1009" notifications

----------------------------------------------------------
4. Known Issues
----------------------------------------------------------
- None

----------------------------------------------------------
5. Programming Information
----------------------------------------------------------
- These devices can be updated using a VNM (Virtual NetLinx Controller)
but the update will go much faster if you can connect to a physical
NetLinx controller. VNM update could take up to 2 hours but
using a physical controller should take less than an hour.

- The update takes place in 3 stages. The first part of the update
happens during the Firmware Transfer in NetLinx Studio. Once that
transfer has completed the device will then continue the update and
show its progress in the Update Status page of the devices webgui.
This must be selected prior to update and then it can be monitored.
Once that update shows as completed the unit will then display the
last stage of the update on a display connected to the HDMI output.
The device will reboot when it has completed the full update.

----------------------------------------------------------
6. Notable Points
----------------------------------------------------------
- These units have a web interface that is accessible by entering
the IP of the device into a web browser. This may indicate there
is a certificate error, but you can select the Advanced option at
the bottom and proceed to the page. A new certificate can be loaded
via the web interface.


Related Products

  • CTP-1301

    Presentation Connectivity and Transport Kit