Last Updated: Jan 14
Release Notes
Product: DXFP-RX-4K60
Description: DXLink 4K60 HDMI Fiber Receiver Module
FG#: FG1010-565-01
FG1010-565-02 (TAA)
File Name: SW1010-565-0X_DXFP-RX-4K60_1_7_1
Release Date: 5/5/2021
Firmware Version: v1.7.1
1. Prerequisites
2. Features added in this release
3. Fixes in this release:
4. Known Issues
5. Programming Information
6. Notable Points
----------------------------------------------------------
1. Prerequisites
----------------------------------------------------------
- Directly connected DXFP-TX-4K60 v1.7.1 (or later)
- Enova DGX 800/1600/3200/6400 Switcher FW v3.8.13 (or later)
- Enova DGX 100 Series Controller FW v1.8.90 (or later)
- NetLinx Studio v4.3.1519 (or later)
----------------------------------------------------------
2. Features added in this release:
----------------------------------------------------------
- Initial Release
----------------------------------------------------------
3. Fixes in this release:
----------------------------------------------------------
- Fixed issue where sending RXCLR would require reboot to send other commands
- Fixed problem where DVI HDCP1.4 signal through TX-RX pair results in snow after
hotplug of HDMI cable
- Improved ID button functionality to match expected results as outlined in manual
- Improved how TX WebGUI pages get refreshed when connection mode changes
- Fixed "No Video" issue for RX after hotplug or power cycle when connected to DGX or DVX
----------------------------------------------------------
4. Known Issues
----------------------------------------------------------
- When scaler is set to BYPASS, some image settings on the web interface are invalid
- When connectoin mode is NDP, the Controller URL cannot be set as IP on web, but only MAC addrass. for TCP/UDP mode vice-versa.
----------------------------------------------------------
5. Programming Information
----------------------------------------------------------
- These devices can be updated using a VNM (Virtual Netlinx Controller)
but the update will go much faster if you can connect to a physical
Netlinx controller. VNM update could take up to 2 hours but
using a physical controller should take less than an hour.
----------------------------------------------------------
6. Notable Points
----------------------------------------------------------
- PLEASE READ the Quick Start Guide in regard to the DIP switches located on the
DXLink 4K60 HDMI Fiber Receiver Module before attempting to connect to the network.
- These units have a web interface that is accessible by entering
the URL of the device into a web browser. This may indicate there
is a certificate error, but you can select the Advanced option at
the bottom and proceed to the page. A new certificate can be loaded
via the web interface.
- This web interface is only available when connected to a DXLink 4K60 Fiber Transmitter.
It is disabled when connected to other devices or a switcher.
- This device has a default static IP: 192.168.1.2 when it isn't assigned a dynamic IP
by DHCP server or auto-setup porcess.
download
