DXLink 4K60 Receiver Firmware v1.8.3

Note: this is an old version. The current version is: DXLink 4K60 Receiver Firmware v1.8.4. ×

Last Updated: Feb 10

Release Notes

Product: DX-RX-4K60
Description: DXLink 4K60 HDMI Receiver Module

FG#: FG1010-512-01
         FG1010-512-02 (TAA)

File Name: SW1010-512-0X_DX-RX-4K60_v1_8_3
Release Date: 10/25/2022
Firmware Version: v1.8.3

1. Prerequisites
2. Features added in this release
3. Fixes in this release:
4. Known Issues
5. Programming Information
6. Notable Points

----------------------------------------------------------
1. Prerequisites
----------------------------------------------------------

- Directly connected DX-TX-4K60 v1.6.7 (or later)
- Enova DGX 800/1600/3200/6400 Switcher FW v3.8.13 (or later)
- Enova DVX-2265-4K/DVX-3266-4K Switcher FW v1.9.4 (or later)
- Enova DGX 100 Series & DVX 4K Series Controller FW v1.6.200 or v1.8.90 (or later)
- NetLinx Studio v4.3.1519 (or later)

----------------------------------------------------------
2. Features added in this release:
----------------------------------------------------------

- Replaced MCU due to EOL parts.  FW updated to support new MCU processor

----------------------------------------------------------
3. Fixes in this release:
----------------------------------------------------------

- Fixed issue in TX/RX that caused RS232 strings to be passed out of order
Note: There is a known issue with EVEN/ODD parity that requires hotfix v1.8.3.2 from help.harmanpro.com  

Fixed in previous release v1.8.0
- Fixed Set Connection to Controller to support changing ICSP Port Number and URL hostname
- Fixed Standalone webgui issue to allow changing Static IP and default Gateway together
- Corrected issue causing IR File to be erased on upgrade (IR file should remain on subsequent upgrades)
- TX/ RX to change Eth0 default fallback to prevent conflict with DGX IO card IP scheme

----------------------------------------------------------
4. Known Issues
----------------------------------------------------------

- When scaler is set to BYPASS, some image settings on the web interface are invalid
- There is a known issue with EVEN/ODD parity that requires hotfix v1.8.3.2 from help.harmanpro.com

----------------------------------------------------------
5. Programming Information
----------------------------------------------------------

- These devices can be updated using a VNM (Virtual Netlinx Controller) but the update will go much faster if you can connect to a physical Netlinx controller. VNM update could take up to 2 hours but using a physical controller should take less than an hour.

----------------------------------------------------------
6. Notable Points 
----------------------------------------------------------

- PLEASE READ the Quick Start Guide in regard to the DIP switches located on the DXLink 4K60 Receiver before attempting to connect to the network.

- These units have a web interface that is accessible in by entering the URL of the device into a web browser. This may indicate there is a certificate error, but you can select the Advanced option at the bottom and proceed to the page. A new certificate can be loaded via the web interface.

- This web interface is only available when connected to a DXLink 4K60 Transmitter. It is disabled when connected to other endpoint devices or a switcher.

- This device has a default static IP: 192.168.1.2 when it isn't assigned a dynamic IP by DHCP server or auto-setup porcess.


Related Products