Last Updated: Mar 16
Changes in This Release Since Version 2.4.23:
- Fixed a NAND memory management problem where single memory bit errors were not being corrected before being copied into RAM
- Fixed a NAND memory management problem where blocks that went bad were not being marked and skipped when upgrading firmware
- Fixed the upgrade process when a corrupt or incomplete kit file was sent to the panel and was upgraded to the NAND memory; the corrupt or incomplete kit files are now removed from the system upon reboot
- Added a popup indicating failed firmware upgrade attempts
- Fixed problem with displaying dynamic images from a Ganz camera
- Fixed problem with displaying motion jpeg (mjpeg) images from a Ganz camera
- Fixed a race condition in which the panel hangs on boot logo on reboot/power on
- Fixed a fault in which the panel is unresponsive after entering sleep/backlight off
- Fixed small issue with dynamic images related to Panasonic cameras
- Fixed the way the number of panel ports/channels/levels are reported to the master to reduce the amount of memory required by the master to maintain states
Known Issues:
The following track items are still unresolved:
- In landscape mode, cross hair follows on "Touch Settings"
- Direct level control, cursor trail jitter on Bargraph and Joystick levels
- Image cache status values are not updated properly
- If ^BVT send command is sent twice, the panel locks up
- Demo pages do not display correctly in portrait mode
- Panel locks up when running .jpg s/w dynamic image
- Stability test failures
- Cache send commands are not working properly
- "set ip" telnet command is not working
- Device name field only allows limited special characters