DXLink 4K60 Transmitter Firmware v1.6.7

Last Updated: Feb 05, 2021

Release Notes

Product: DX-TX-4K60
Description: DXLink 4K60 HDMI Transmitter Module

FG#: FG1010-312-01
FG1010-312-02 (TAA)

File Name: SW1010-312-0X_DX-TX-4K60_v1_6_7
Release Date: 12/28/2020
Firmware Version: v1.6.7


1. Prerequisites
2. Features added in this release
3. Fixes in this release:
4. Known Issues
5. Programming Information
6. Notable Points


----------------------------------------------------------
1. Prerequisites
----------------------------------------------------------

- Directly connected DX-RX-4K60 v1.6.7 (or later).
- Enova DGX 800/1600/3200/6400 Switcher FW v3.8.7 (or later)
- Enova DVX-2265-4K/DVX-3266-4K Switcher FW v1.8.4 (or later)
- Enova DGX 100 Series & DVX 4K Series Controller FW v1.8.86 (or later)
- NetLinx Studio v4.3.1519 (or later)

----------------------------------------------------------
2. Features added in this release:
----------------------------------------------------------
- None

----------------------------------------------------------
3. Fixes in this release:
----------------------------------------------------------
- Improved handling of HDCP content to prevent instability during switching or failed authentication
- Corrected networking/transport issues causing endpoints to drop offline or be offline on boot
- Fixed "No Video" issue for RX after hotplug or power cycle when connected to DGX or DVX
- Improved scaler performance and reporting of proper formats in Web Interface
- Fixed binding and device addressing issues
- Improved switching performance and stability when connected to DVX or DGX
- Improved downstream stability when source is switched upstream in point to point scenario
- Fixed Web Interface and Video Details reporting issue for TX when no video present
- Corrected TX EDID issue on boot presenting wrong EDID
- Restored correct content/blank/logo after disabling Testpattern
- Fixed audio details or encoding reporting errors
- Improved video details reporting in Web Interface when no signal present
- Corrected serial strings to be sent with proper as Hex format
- Fixed issue preventing TX to pass DVI signals to switcher

----------------------------------------------------------
4. Known Issues
----------------------------------------------------------
- TX misreports connection type after moving from Static setup to auto-Setup.


----------------------------------------------------------
5. Programming Information
----------------------------------------------------------
- The KIT file firmware download can take up to 20 minutes.
Please be patient during upgrades.

- These devices can be updated using a VNM (Virtual Netlinx Controller)
but the update will go much faster if you can connect to a physical
Netlinx controller. VNM update could take up to 2 hours but
using a physical controller should take less than an hour.


----------------------------------------------------------
6. Notable Points
----------------------------------------------------------
- PLEASE READ the Quick Start Guide in regard to the DIP switches
located on the DXLink 4K60 HDMI Transmitter or Receiver Module
before attempting to connect to the network.

- After a FACTORYAV (ICSP) or RESET FACTORY (telnet) command,
a reboot of the endpoint is required.

- These units have a web interface that is accessible by entering
the URL of the device into a web browser. This may indicate there
is a certificate error, but you can select the Advanced option at
the bottom and proceed to the page. A new certificate can be loaded
via the web interface.

- The web interface of DXLink 4K60 HDMI Transmitter & Receiver Modules
will be auto disabled when auto setup with the Enova DGX 100 series
(with 4K60 DXLink I/O boards) or DVX 4K series.


Related Products