DXFP-TX-4k60 Firmware v1.7.6

Note: this is an old version. The current version is: DXFP-TX-4k60 Firmware v1.8.4. ×

Last Updated: Jan 26

Release Notes

Product: DXFP-TX-4K60
Description: DXLink 4K60 HDMI Fiber Transmitter Module

FG#: FG1010-365-01
FG1010-365-02 (TAA)

File Name: SW1010-365-0X_DXFP-TX-4K60_v1_7_6
Release Date: 12/28/2021
Firmware Version: v1.7.6

1. Prerequisites
2. Features added in this release
3. Fixes in this release:
4. Known Issues
5. Programming Information
6. Notable Points

----------------------------------------------------------
1. Prerequisites
----------------------------------------------------------

- Directly connected DX-RX-4K60 v1.7.1 (or later).
- Enova DGX 800/1600/3200/6400 Switcher FW v3.8.13 (or later)
- Enova DGX 100 Series Controller FW v1.8.90 (or later)
- NetLinx Studio v4.3.1519 (or later)

----------------------------------------------------------
2. Features added in this release:
----------------------------------------------------------
- None

----------------------------------------------------------
3. Fixes in this release:
----------------------------------------------------------

- Fixed issue that could cause TX/RX to go offline or not come back online after reboot or upgrade
- Improved Set Connection to allow changing ICSP Port Number and use URL hostname (Note: Don't use "-" in hostname)
- Improved ICSP LED-DIS/LED-EN function to match legacy AMX endpoint
- Improved IR function, added support to upload IR HEX Code for IR Local control by User on Standalone WebGUI
- Added ICSP commands "LOG_RTC-YYYY/MM/DD hh:mm:ss" / "?LOG_RTC"to set/get real time clock
- Corrected issue where TX does not report Audio Word length of 24-bits
- Fixed issue where TX misreports connection type after changing from static setup to Auto-Setup
- Resolve issue where some input port display NO Connection of TX on WebGUI but video can pass to downstream

Fixed in previous release v1.7.1
- Fixed some reporting issues on WebGUI Scaling Resolution and Video Output Details
- Improved how RX WebGUI pages are refreshed when connection mode changes
- Fixed issue where sending RXCLR would require reboot to send other commands
- Corrected a 4K to 2K switching issue that sometimes resulted in a blue screen
- Fixed problem where DVI HDCP1.4 signal through TX-RX pair results in snow after hotplug of HDMI cable
- Improved ID button functionality to match expected results as outlined in manual

----------------------------------------------------------
4. Known Issues
----------------------------------------------------------
- None

----------------------------------------------------------
5. Programming Information
----------------------------------------------------------
- These devices can be updated using a VNM (Virtual Netlinx Controller)
but the update will go much faster if you can connect to a physical
Netlinx controller. VNM update could take up to 2 hours but
using a physical controller should take less than an hour.

----------------------------------------------------------
6. Notable Points
----------------------------------------------------------
- PLEASE READ the Quick Start Guide in regard to the DIP switches located
on the DXLink 4K60 Transmitter before attempting to connect to the network.

- These units have a web interface that is accessible by entering
the URL of the device into a web browser. This may indicate there
is a certificate error, but you can select the Advanced option at
the bottom and proceed to the page. A new certificate can be loaded
via the web interface.

- This web interface is only available when connected to a DXLink 4K60 Fiber Receiver.
It is disabled when connected to a switcher.

- This device has a default static IP: 192.168.1.2 when it isn't assigned a dynamic IP
by DHCP server or auto-setup porcess.


Related Products